Accessing The Nxb-Knx Webconsole Via Zero-Config - AMX NetLinx Interface NXB-KNX Operation/Reference Manual

Configuration
FIG. 6
Workspace Bar - Zero-Config tab
Refer to the NetLinx Studio online help for details on using Zero-Config.

Accessing the NXB-KNX WebConsole via Zero-Config

Assuming that the NXB-KNX resides on the same LAN as the PC running NetLinx Studio, and the NetLinx
Master to which the NXB-KNX is connected, you can access the NXB-KNX via the Zero-Config feature in
Netlinx Studio, as described below:
1.
In NetLinx Studio (version 3.0 or higher), right-click inside the Zero-Config tab of the Workspace Bar to
access the Zero-Config context menu (FIG. 7).
FIG. 7 NetLinx Studio - Zero-Config context menu
2.
Select Refresh List to generate an initial listing of all Zero-Config devices detected (FIG. 8).
3.
Click the plus symbol (+) to expand any device in the Zero-Config list. The device's current IP Address is
listed below the device name (FIG. 8):
FIG. 8 Workspace Bar - Zero-Config tab
6 NXB-KNX Operation/Reference Guide