Table of Contents
Advertisement
MBR1400 | USER MANUAL – Firmware version 4.4
CRADLEPOINT
General Settings
7.1.3
Enabled: Select/deselect to
enable/disable.
Force NAT: Normally NAT is part of the
Routing Mode setting which is selected on
the LAN side in Network Settings → WiFi
/ Local Networks. Select this option to
force NAT whenever this WAN device is
being used.
Priority: This number controls failover and
failback order. The lower the number, the
higher the priority and the more use the
device will get. This number will change
when you move devices around with the
priority arrows in the WAN Interfaces list.
Load Balance: Select to allow this device
to be available for the Load Balance pool.
Download bandwidth: Defines the default
download bandwidth for use in Load
Balance or QoS (quality of service, or
traffic shaping) algorithms. (Range: 128 Kb/s to 1 Gb/s.)
Upload bandwidth: Defines the default upload bandwidth for use in Load Balance and QoS (quality of service, or
traffic shaping) algorithms. (Range: 128 Kb/s to 1 Gb/s.)
MTU: Maximum transmission unit. This is the size of the largest protocol data unit that the device can pass.
(Range: 46 to 1500 Bytes.)
Hostname (This only shows for certain devices.)
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 135
Advertisement
Table of Contents
