Table of Contents
Advertisement
MBR1400 | USER MANUAL – Firmware version 4.4
CRADLEPOINT
Local IP Networks
6.8.1
Local IP Networks displays the following information for each network:
Network Name and IP address/Netmask (along the top bar)
Enabled: Yes/No
Multicast Proxy (Enabled/Disabled)
DHCP Server (Enabled/Disabled)
Schedule (Enabled/Disabled – See
the Schedule tab in the Local Network
Editor)
VRRP Failover State (Disabled,
Backup, or Master)
IPv4 Routing Mode (NAT, Standard,
IP Passthrough, Hotspot, Disabled)
IPv6 Addressing Mode (SLAAC
Only, SLAAC with DHCP, Disable
SLAAC and DHCP)
Access Control (Admin Access, UPnP Gateway, LAN Isolation)
Attached Interfaces (Ethernet ports, WiFi, VLAN)
Click Add to configure a new network, or select an existing network and click Edit to view configuration options.
HotSpot (Captive Portal)
When you set a network as a "Hotspot" under Routing Mode, you will also need to:
1) Configure hotspot settings under System Settings → Hotspot Services. Click on Configure to link to that page.
2) If you want a hotspot that includes WiFi, set one of your WiFi interfaces to "Open" for its Security Mode and attach
this interface to your hotspot network. Otherwise guests will need to know the password to connect to the WiFi
network even before viewing a Terms of Service page (or other hotspot options). Also, make sure your WiFi
interface is "Enabled".
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 101
Advertisement
Table of Contents
