Table of Contents
Advertisement
MBR1400 | USER MANUAL – Firmware version 4.4
CRADLEPOINT
Local Network Editor
6.8.2
Click Add or select a network and click Edit to open the Local Network Editor to make configure a LAN. The Local
Network Editor contains the following tabs: General Settings, IPv4 Settings, IPv6 Settings, Interfaces, Access Control,
IPv4 DHCP, IPv6 Addressing, Multicast Proxy, Schedule, VRRP, STP, and Wired 802.1X.
General Settings:
Enabled: Push to manually disable a network. Also,
some settings could cause a network to be
automatically disabled: click here to re-enable the
network.
Name: This primarily helps to identify this network
during other administration tasks.
Hostname: [Default: cp (for CradlePoint)] The
hostname is the DNS name associated with the
router's local area network IP address.
NOTE: You can access the router's administration pages by
typing the hostname into your browser, so if you change "cp" to
another hostname, you can access the administration pages
through the new hostname.
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 102
Advertisement
Table of Contents
