Table of Contents
Advertisement
MBR1400 | USER MANUAL – Firmware version 4.4
CRADLEPOINT
IPv4 DHCP:
Changing settings for the IPv4 DHCP server is optional. The default selections are almost always sufficient.
DHCP Server: (Default: Enabled) When the DHCP server is enabled, users of your network will be able to automatically
connect to the Internet without any special configuration. It is recommended that you leave this enabled. Disabling the
DHCP server is only recommended if you have another DHCP server on your network and it is configured properly.
Range Start and Range End: These designate the range of values in the reserved pool of IP addresses for the DHCP
server. Values within this range will be given to any DHCP enabled computers on your network. The default values are
almost always sufficient (default: 72 to 200, as in 192.168.0.72 to 192.168.0.200).
Example: The router uses an IP address of 192.168.0.1 for its primary network by default. A computer designated as a Web server has a static IP
address of 192.168.0.3. Another computer is designated as an FTP server with a static IP address of 192.168.0.4. The starting IP address for the
DHCP server needs to be 192.168.0.5 or higher.
Lease Time: [Default: 720 minutes (12 hours)] The lease time specifies how long DHCP-enabled computers will wait
before requesting a new DHCP lease. Smaller values are better suited to busy environments.
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 107
Advertisement
Table of Contents
