Yamaha T135SE Service Manual page 248

1
1
2
YamahaT135.COM
Yamaha T135 Service Manual
a
7-18
FRONT BRAKE
2. Remove:
9clips
9brake pad retaining pin
9brake pads 1
9brake pad spring
3. Measure:
9brake pad wear limit a
Out of specification → Replace the brake
pads as a set.
Brake pad wear limit
0.8 mm (0.03 in)
4. Install:
9brake pad spring
9brake pads
NOTE:
Always install new brake pads and a new brake
pad spring as a set.
MMMMMMMMMMMMMMMMMMMMMMMM
a. Connect a clear plastic hose 1 tightly to the
bleed screw 2. Put the other end of the
hose into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with
your finger.
c. Tighten the bleed screw.
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
d. Install new brake pads and a new brake pad
spring.
NOTE:
Make sure the brake pad spring is installed cor-
rectly as shown.
LLLLLLLLLLLLLLLLLLLLLLLL
CHAS