Yamaha T135SE Service Manual page 173

3
4
3
1
2
1
a
YamahaT135.COM
Yamaha T135 Service Manual
2
1
5
1
2
b
CLUTCH
4. Tighten:
9clutch boss nut 1
NOTE:
While holding the clutch boss 2 with the univer-
sal clutch holder 3, tighten the clutch boss nut.
Universal clutch holder
90890-04086
5. Bend the lock washer tab along a flat side
of the nut.
6. Lubricate:
9seat plate
9cushion ring
9friction plates #1
9friction plate #2
9clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
7. Install:
9seat plate 1
9cushion ring 2
9friction plate #2 3
9clutch plates 4
9friction plates #1 5
NOTE:
9Make sure to face the cushion ring 2 toward
as shown illustration, and then install it onto
the clutch boss.
9First, install the seat plate, cushion ring and
then alternate between a clutch plate and a
friction plate.
8. Install:
9clutch springs
9clutch pressure plate 1
9clutch pressure plate bolts 2
NOTE:
9Align the punch mark a on the pressure plate
with clutch housing mark b.
9Tighten the clutch pressure plate bolts in
stages and in a crisscross pattern.
9. Adjust:
9clutch release system
Refer to "ADJUSTING THE
RELEASE SYSTEM" in chapter 3.
4-57
ENG
70 Nm (7.0 m•kg, 50 ft•lb)
12 Nm (1.2 m•kg, 9.0 ft•lb)
CLUTCH