Repeater Lockout - Icom IC-V82 Instruction Manual

D D Tone information
Some repeaters require different tone system to be accessed.
DTMF TONES
While pushing [PTT], push the desired DTMF keys (0–9,
[A• ], [B• ], [C•
FUNC CALL MR
]) to transmit DTMF tones.
[✱•
ENT
• [✱• ] transmits tone "E," [#•
ENT
• The transceiver has 16 DTMF memory channels (p. 27).
1750 Hz TONE
While pushing [PTT], push [Y Y ] or [Z Z ] to transmit a 1750 Hz
tone signal.
✔ Convenient
Tone scan function: When you don't know the subaudible
tone used for a repeater, the tone scan is convenient for de-
tecting the tone frequency.
Push [A• ], then push [3•
FUNC
• Push [D• ] to cancel the scan.
CLR
• When the required tone frequency is detected, the scan pauses.
] and
], [D• ], [#•
CLR BANK
] transmits tone "F."
BANK
. ] to start the tone scan.
T SCAN
REPEATER OPERATION

■ Repeater lockout

This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.
q While pushing and holding [Y Y ] and [Z Z ], turn the power ON
to enter .
INITIAL SET MODE
w Push [Y Y ] or [Z Z ] several times until "RLO" appears.
e Rotate [VOL] to select the repeater lockout function to
"RP," "bU" or OFF.
• "RP": Transmit is inhibited when a signal with un-matched sub-
audible tone is received.
• "bU": Transmit is inhibited when a signal is received.
r Push [✱•
] (or [D•
ENT CLR
5
INITIAL SET MODE
USING
]) to exit .
INITIAL SET MODE
5
19