Auto Repeater; Repeater Lockout - Icom IC-2100H Instruction Manual

Auto repeater

(USA version)
The USA version automatically activates the repeater settings
(DUP or – DUP and tone encoder ON/OFF) when the operat-
ing frequency falls within the general repeater output fre-
quency range and deactivates them when outside of the
range.
D Setting the auto repeater function ON/OFF
Push [PWR] to turn power OFF.
While pushing [SET] (far left switch), turn power ON to
enter initial set mode.
Push [SET] one or more times until the "RPt" display ap-
pears as shown below.
5 9
1
Auto repeater function is
turned OFF
Rotate the tuning dial to turn the auto repeater function to
"R1," "R2" or OFF.
• "R1": auto repeater is ON, tone encoder is OFF.
• "R2": auto repeater is ON, tone encoder is ON.
Push [PWR] to exit initial set mode.
INITIAL SET MODE
USING
X
5 9
1
Auto repeater function is ON,
tone encoder is OFF
REPEATER OPERATION
D Frequency range and offset direction
FREQUENCY RANGE
145.200–145.495 MHz
146.610–146.995 MHz
147.000–147.395 MHz

Repeater lockout

This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.
Push [PWR] to turn power OFF.
While pushing [SET] (far left switch), turn power ON to
enter initial set mode.
Push [SET] one or more times until the "RLO" display ap-
pears as shown below.
Repeater lockout function is
turned OFF
Rotate the tuning dial to turn the repeater lockout function
to "RP," "BU" or OFF.
• "RP": Transmit is inhibited when the tone squelch is closed.
• "BU": Transmit is inhibited when a signal is received.
Push [PWR] to exit initial set mode.
5
DUPLEX DIRECTION
"DUP –" appears
"DUP" appears
INITIAL SET MODE
USING
X
Transmit is inhibited when the
tone squelch is closed
25