Scan Resume Condition - Icom IC-V82 Instruction Manual

D Memory scan watch
While operating on a VFO frequency, memory scan watch
monitors for signals in each memory channel in sequence,
every 5 sec.
q Push [C•
] to select memory mode, if necessary.
MR
• "X" appears.
wPush [A•
], then push [5•
FUNC
scan.
e Push [A•
], then push [7•
FUNC
• VFO is displayed, then the decimal point ".", on the frequency
readout blinks.
• When the signal is detected on the priority channel, the watching
is suspended according to the setting of the scan resume condi-
tion.
VFO frequency
5 sec.
r Push [D•
] to stop the watching.
CLR
] to start the memory
SCAN
] to start the watching.
PRIO
Mch 3
Mch 2 Mch 4
Memory
scan
Mch 1 Mch 5
Priority channel
SKIP
Mch 199 Mch 6
50 msec.

■ Scan resume condition

When a signal is received during scanning, the scan resume
condition determines what action the transceiver takes. The
transceiver has 2 scan resume conditions available as
illustrated below. Use
SET MODE
suits your needs.
q Push [A•
], then push [8•
FUNC
wPush [Y Y ] or [Z Z ] several times until "SCP" or "SCt" ap-
pears.
e Rotate [VOL] to select the desired scan resume condition.
• Pause scan:
When receiving a signal, scan pauses on
the signal until it disappears. Resumes
2 sec. after the signal disappears.
• Timer scan:
When receiving a signal, scan pauses on
the signal for 5 sec., 10 sec. or 15 sec.,
then resumes.
r Push [✱•
] (or [D•
ENT CLR
SCAN OPERATION
SET MODE
USING
to select the one which best
] to enter .
SET SET MODE
Pause scan
Timer scan
]) to set and exit .
SET MODE
8
8
33