I Offset Frequency; I Repeater Lockout - Icom IC-V8000 Instruction Manual

4
REPEATER OPERATION

I Offset frequency

When communicating thorough a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
q Push [SET(LOCK)] to enter set mode.
w Push [SET(LOCK)] or [MW(S.MW)] until "±" and offset fre-
quency appear.
[SET(LOCK)]
e Rotate the tuning dial to set the desired offset frequency.
r Push [TONE(T-SCAN)] to exit set mode.
z Push [
SET
SET
x Push [
SET
B
and offset frequency appear.
c Push [Y] or [Z] to set the desired offset.
• Direct frequency entry from the keypad is not possi-
ble.
v Push [
CLR
21
SET MODE
USING
B(D-OFF)] to enter set mode.
B(D-OFF)] or [ C(T-OFF)] until "±"
ENT
Push
A(MW)] to exit set mode.

I Repeater lockout

This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.
q Push [PWR] to turn power OFF.
w While pushing [SET(LOCK)], turn power ON to enter initial
set mode.
While pushing [SET(LOCK)],
turn power ON.
e Push [SET(LOCK)] or [MW(S.MW)] several times until the
"RLO" display appears as shown below.
r Rotate the tuning dial to turn the repeater lockout function
to "RP," "BU" or OFF.
Repeater lockout function is
turned OFF.
• "RP": Transmit is inhibited when a signal with un-matched sub-
audible tone is received.
• "BU": Transmit is inhibited when a signal is received.
t Push [PWR] to exit initial set mode.
INITIAL SET MODE
USING
Repeater lockout function is
turned ON.