Weather Channel Operation (Ic-V82 [Usa]/[Csa] Versions Only) - Icom IC-V82 Instruction Manual

■ Weather channel operation
D D Weather channel selection
q Push [C•
] several times to select weather channel group.
MR
Weather channel group indication
w Push [Y Y ] or [Z Z ] several times to select the desired
weather channel.
e Push [C•
] to select memory mode, or push [D•
MR
select VFO mode.
D D Weather alert function
An NOAA broadcast station transmits weather alert tone be-
fore important weather announcements. When the weather
alert function is turned ON, the selected weather channel is
monitored each 5 sec. for the announcement. When the alert
signal is detected, the "ALt" and the WX channel are dis-
played alternately and sounds a beep tone until the trans-
ceiver is operated. The previously selected (used) weather
channel is checked periodically during standby or while scan-
ning.
(IC-V82 [USA] version only)
q Select the desired weather channel.
w Turn the weather alert function ON in
➥ Push [A•
FUNC
➥ Push [Y Y ] or [Z Z ] to select the weather alert item, then
rotate [VOL] to set ON.
➥ push [✱•
ENT
e Sets the desired stand-by condition.
• Selects VFO, memory or call channel.
• Scan or priority watch operation can also be selected.
] to
CLR
r When the alert is detected, a beep sounds and the follow-
ing indication will be displayed.
Shows above indications alternately.
t Turn the weather alert function OFF in
NOTE: While receiving a signal (on a frequency other than
the weather alert ON frequency), the receiving signal or
audio will be interrupted momentarily every 5 sec.
in case the alert function is turned ON. This symptom is
caused by the WX alert function. To cancel these symp-
toms, set the weather alert item OFF in
OTHER FUNCTIONS
SET MODE
] and [8• ] to enter
SET MODE
SET
] (or [D• ]) to exit
CLR SET MODE
SET MODE
SET MODE
12
.
.
.
12
.
(approx.)
.
69