Icom IC-V82 Instruction Manual page 47

D Setting subaudible tones for tone squelch operation
Separate tone frequencies can be select for tone squelch op-
eration rather than repeater operation (the same range of
tones is available— see right below). Like the repeater tones,
these are set in .
SET MODE
q Select VFO or memory channel.
w Push [A•
], then push [8•
FUNC
e Push [Y Y ] or [Z Z ] several times until "Ct" appears when se-
lecting CTCSS, or "dt" appears when selecting DTCS.
• " " blinks when selecting CTCSS, or " " blinks when selecting
DTCS.
r Rotate [VOL] to select the desired subaudible tone.
t Push [✱•
] (or [D•
ENT CLR
and exit .
SET MODE
• The recommended CTCSS frequencies or DTCS codes are
shown at previous page.
] to enter .
SET MODE
SET
D
]) to program the selected tone
SUBAUDIBLE TONES
When is selected from memory mode.
SET MODE
The tone squelch frequency is not stored in the selected
memory channel unless you follow steps y and u.
y Push [A•
], then push and hold [C•
FUNC
transfer the contents to VFO.
• 3 beeps are emitted.
• VFO mode is selected automatically.
u Push [A•
], then push and hold [C•
FUNC
• 3 beeps are emitted.
• Available CTCSS tone frequency list
67.0 85.4 107.2 136.5
69.3 88.5 110.9 141.3
71.9 91.5 114.8 146.2
151.4
74.4 94.8 118.8
77.0 97.4 123.0 156.7
100.0 127.3 159.8
79.7
103.5 131.8 162.2
82.5
9
] for 1 sec. to
MR
] for 1 sec.
MR
(unit: Hz)
165.5 186.2 210.7 254.1
167.9 189.9 218.1
171.3 192.8 225.7
173.8 196.6 229.1
177.3 199.5 233.6
179.9 203.5 241.8
183.5 206.5 250.3
9
35