Icom IC-V82 Instruction Manual page 16

2
PANEL DESCRIPTION
!0 [DATA] JACK
Connect to a PC or GPS receiver via the RS-232 cable (D-
sub 9 pin) for data communication in the RS-232 format.
to [DATA] jack
TxD GND
RxD
2.5(d) mm
When making the connection between your transceiver and
PC or other device, ensure that the correct connections are
made otherwise data communications may fail.
4
Pin 2 (RxD),
Pin 3 (TxD),
Pin 5 (GND)
5
1
9 6
Less than
RS-232
10(d) mm
(DB-9 female)
D Keypad
[A• ]
FUNC
A
Access to secondary function.
FUNC
[B• ]
CALL
B
Selects the call channel. (p. 21)
CALL
[C• ]
MR
C
➥ Selects a memory mode. (p. 21)
MR
➥ After pushing [A•
gramming/editing mode. (pgs. 22–24)
➥ After pushing [A•
VFO/memory or call channel contents into
memory channel/VFO when pushed and held
for 1 sec. (pgs. 22–24)
[D• ]
CLR
D
Selects VFO mode, aborts direct frequency input,
CLR
or cancels scanning, etc. (pgs. 13, 30)
[1• ]
TONE
1
➥ Input digit "1" during frequency input, memory
TONE
channel selection, etc. (pgs. 13, 21)
➥ After pushing [A•
tone function. (pgs. 17, 34)
[2• . ]
P BEEP
2
➥ Input digit "2" during frequency input, memory
P.BEEP
channel selection, etc. (pgs. 13, 21)
➥ After pushing [A•
function ON and OFF. (p. 36)
], enter into memory pro-
FUNC
], programs/transfers
FUNC
], selects the subaudible
FUNC
], turns the pocket beep
FUNC