Console 1; Ce90 - Smooth Fitness SMOOTH CE-9.0 ELLIPTICAL User Manual

32 SMOOTH CE 9.0 ELLIPTICAL
Wireless Heart Rate
WIRELESS CHEST BELT MONITOR
CE 9.0 includes the pre‐installed receiver with console. The chest belt is included with the equipment. For sanitary reasons
it is recommended not to share the chest belt with any other person. To purchase an additional chest belt from our website
go to www.smoothfitness.com
HOW TO WEAR THE WIRELESS CHEST BELT
The monitor has two components: a chest belt and a
sensor unit (see the drawing below). Insert the tab on
one end of the chest best into one end of the sensor
unit, as shown in the insert drawing. Press the end of
the sensor unit under the buckle on the chest belt. The
tab should be flush with the front of the sensor unit.
Next, wrap the chest belt monitor around your chest
and attach the other end of the chest belt to the
sensor unit. Adjust the length of the chest belt, if
necessary. The chest belt monitor should be under
your clothes, tight against your skin, and as high
under the pectoral muscles or breasts as is
Comfortable. Make sure that the logo on the sensor
unit is facing forward and is right-side-up Pull the
sensor unit away from your body a few inches and
locate the two electrode areas on the inner side (the
electrode areas are covered by shallow ridges). Using
saline solution such as saliva or contact lens solution,
wet both electrode areas. Return the sensor unit to a
position against your chest.
or call 1‐888‐800‐1167.
STORAGE AND MAINTENANCE
Dry the chest belt monitor after each use. The chest
belt monitor is activated when you wet the electrode
areas and put on the chest belt monitor; the chest
belt Monitor shuts off when it is removed and the
electrode areas are dried. If the chest belt monitor is
not dried after each use, the battery may be drained
prematurely
•
Store the chest belt monitor in a warm, dry place.
Do not store the chest belt monitor in a plastic
bag or other container that may trap moisture.
•
Do not excessively bend or stretch the sensor
unit when using or storing the chest belt monitor.
•
Clean the sensor units using a damp cloth- never
use alcohol, aba dives, or chemicals. Hand wash
and air dry the chest belt.
•
If the chest belt monitor does not function
properly, try the suggestions below.
•
Make sure that you are wearing the chest belt
monitor as described at the left. Note: If the chest
belt monitor does not function when positioned as
described, move it slightly lower or higher on your
chest.
•
Use saline solution such as saliva or contact lens
solution to wet the two electrode areas on the
sensor unit. If chest belt readings do not appear
until you begin perspiring, re-wet the electrode
areas.
•
To use the chest belt heart rate, position yourself
near the console. It is recommended that the
user be within arm's length of the console.
•
The chest belt monitor is designed to work with
people who have normal heart rhythms. Chest
belt reading problems may be caused by medial
conditions such as premature ventricular
contractions (pvcs), tachycardia bursts, and
arrhythmia
•
The operation of the chest belt monitor can be
affected by magnetic interference caused by high
power lines or other sources, if it is suspected
that this is a problem, try relocating the elliptical.