Table of Contents
Advertisement
Program Mode
The Split Function
Key (Split Key)
Press the KEY soft button to change the Key (Split Key) parameter. This parameter sets
the keyboard key that will be the boundary between the left and right hand Programs on the
keyboard. The selected key will be the highest note for the left-hand Split Program. All keys
higher than the Split Key will play the right-hand Program. By default, the Split Key is set to
B3. The Split Key can be selected using Assign
then striking the desired key on the keyboard. The Split Key can also be selected by using the
Alpha Wheel, Previous/Next buttons, or by entering a number using the numbers printed
on the Program/Multi buttons. Split Key can be set to any key between A0 and C8.
Transpose (Split Transposition)
Press the XPOSE soft button to change the Transpose (Split Transposition) parameter.
This parameter allows you to transpose the left-hand Split Program in octaves so that you
can play it in higher or lower octaves. Use the Alpha Wheel or Previous/Next buttons to
set the Transpose value. Transpose can be set to -24, -12, 0, 12, and 24. By default, Split
Transposition is set to +12.
Saving a Split
After setting the Split parameters, the Split can be saved as a Multi so that it can easily be
recalled in Multi Mode. Press the Save button to the left of the display to begin the saving
process.
See Save & Delete User Multis (page 7-12) in the Multi Mode Chapter for details on saving.
Once you have saved your Split as a Multi, you can continue to add Split or Layer Zones to
the Multi until you reach the maximum of four active Zones.
See the Split Function (page 7-8) and The Layer Function (page 7-10) in the Multi Mode
Chapter. Also, once you have saved your Split as a Multi, you can edit controller assignments
and other Multi parameters in Multi Edit Mode (see Multi Edit Mode on page 8-1 for
details)
6-12
, by holding down the Enter button and
Advertisement
Table of Contents
