Table of Contents
Advertisement
Troubleshooting
Common Problems
The wall outlet, power strip, or
extension cord is defective or
damaged.
If there's evidence of the unit receiving power, but operation is abnormal, check if one of
the following might be the issue:
The wall outlet voltage is below 90
volts due to overload.
Powers up, Display is Blank
The Display is blank or difficult to
read.
Audio Problems
If there is no sound from your Artis, check if one of the following might be the issue:
The volume slider is turned down.
The volume control on the audio
system or mixer is turned down.
The signal source selection on the
audio system or mixer is incorrect.
11-2
CAUTION: Do not trouble shoot audio problems using headphones.
Additionally, always be aware of the volume levels on the Artis and
on the connected audio system or mixer.
NOTE: When diagnosing audio problems, set the Artis to play its
Demo Song rather then intermittently pressing keys. This will prevent
any unexpectedly loud volume changes.
Use a different wall outlet, power strip, or
extension cord.
Try a different outlet on a different circuit.
Slowly turn the Display contrast knob
(located above the Alpha Wheel) to adjust the
Display.
Slowly push the volume slider up.
Slowly turn the volume control up.
Set the volume of the audio or mixer to the
lowest level, select the correct signal source,
and then slowly turn up the volume.
Advertisement
Table of Contents
