Table of Contents
Advertisement
Multi Edit Mode
Zone Parameters
The Switch Parameters
• Variation
• Switch 1 through 5
• Pedal SW1a to SW2b
• Variation button & Switch buttons 1 to 5
Assigning controllers to switches and buttons creates a Virtual Parameter in the same way as
the continuous controllers. The following are parameters that affect the behavior of the Foot
Switch and switch button controllers:
Mode
The Mode parameter determines the switching behavior of Foot Switches and buttons.
Momentary
Toggled
Pressing both Previous & Next buttons simultaneously will set this parameter to Toggled.
Dest (Destination)
The Destination parameter determines the Controller Destination for the currently selected
controller in the currently selected Zone. For a list of the Multi Destination Controllers and
their descriptions, see Destination on page 8-19.
Pressing both Previous & Next buttons simultaneously will cycle this parameter through
these common settings: ModWheel, Volume, Sustain, DataInc, Pitch, ProgInc, TransUp, Off.
On Value
The On Value is the MIDI value sent when the switch is set to On. You can set this
parameter to any number between 0 and 127, or to None.
Pressing both Previous & Next buttons simultaneously will set this parameter to 127.
Off Value
The Off Value is the MIDI value sent when the switch is set to Off. You can set this
parameter to any number between 0 and 127, or to None.
Pressing both Previous & Next buttons simultaneously will set this parameter to 0.
8-18
A momentary switch is one that is only in the "on" state when it is pressed.
As soon as you release the switch, it goes into the "off" state.
A toggled switch is one that maintains its state after it is pressed. So, if the
switch is currently in the "off" state, pressing it once will put it in the "on"
state. Pressing it again will put it back in the "off" state.
Advertisement
Table of Contents
