Table of Contents
Advertisement
Programming Your Telephone
Storing The Special Purpose Feature Buttons
In addition to the feature buttons discussed on the previous
page, there are five special purpose buttons that you can ar-
range as needed. These buttons provide the following features:
Assist Button - sends a message to an LCD speakerphone that
lets user know, with a tone and a station message display, that
you need assistance.
Automatic Redial Button - causes the system to automatically
dial (every minute for 10 minutes) the last number that you
dialed and ring the number for approximately 30 seconds.
Response Message Button - makes a non-verbal response to a
SOHVA call (appears in the display of the calling telephone).
l'Fansfer/Conference Autodial Button - enables you to pre-
select telephones to which calls are frequently transferred, al-
lowing a single-key transfer of calls.
Secure Off-Hook Voice Announce (SOHVA) Button - allows
you to deliver a SOHVA call. With this button you can decide,
after hearing a busy signal, whether the called party should be
interrupted in a SOHVA manner. If so, you can press the but-
ton and initiate a SOHVA call.
To select any of the special purpose buttons, proceed as follows:
l
press ITCM,
l
dial+#Atl,
l
press programmable button for button location,
l
dial feature code for button,
7 = ASSIST button, then dial O-9 to choose
pre-programmed message, or dial d to choose
ASSIST message
# = AUTOMATIC REDIAL button
5 = RESPONSE MESSAGE button, then dial O-9 to
choose pre-programmed message
6 = TRANS/CONP autodial button (then dial extension)
8 = SOHVA button
l
press TranslConf, then press another programmable but-
ton location and dial the next feature button storage code
(keep repeating this step until desired buttons are
programmed),
q
l
press SPKR to end,
l
label button locations.
:I:,
;.:
.::
..:.
56
Advertisement
Table of Contents
