Inserting And Deleting Instructions - Omron CQM1 Operation Manual

LSS Capabilities
1, 2, 3...

3-6-10 Inserting and Deleting Instructions

Original Program
00100 00101
00201 00102
Insertion
1, 2, 3...
Deletion
1, 2, 3...
92
1. Bring up the initial display.
2. Input the operand address. It is not necessary to input leading zeroes.
CONT
SHIFT
#
3. Press the SRCH Key to begin the search.
4. Press the SRCH Key to search for the next occurrence of the operand bit.
5. The search will continue until an END instruction or the end of Program
Memory is reached. In this case, an END instruction was reached.
This operation is used to insert or delete instructions from the program. It is pos-
sible in PROGRAM mode only.
RUN
No
To demonstrate this operation, an IR 00105 NO condition will be inserted at
program address 00206 and an IR 00103 NO condition deleted from address
00205, as shown in the following diagram.
00104
00103
10000
Delete
00105
Insert
END(01)
Follow the procedure below to insert the IR 00105 NO condition at address
00206.
1. Bring up the initial display.
2. Input the address where the NO condition will be inserted and press the
Down Arrow Key. It is not necessary to input leading zeroes.
C A
2 0 6
3. Input the new instruction and press the INS Key.
B A F
AND
1 0 5
4. Press the Down Arrow Key to insert the new instruction.
Note For instructions that require more operands, input the operands and
then press the WRITE Key.
Follow the procedure below to delete the IR 00103 NO condition at address
00205.
1. Bring up the initial display.
00000CONT SRCH
F
5
CONT
00200CONT SRCH
SRCH
LD
03197
SRCH
END (01)(3.2KW)
MONITOR PROGRAM
No OK
Address Instruction
00205 AND
Delete
00206 AND NOT
00207 OUT
00208 END(01)
00206READ
↓
AND NOT
00206INSERT?
INS
AND
00207INSERT END
↓
AND NOT
Section 3-1
00005
00005
Operands
00103
Insert
00104
10000
-
00104
00105
00104