Bit Operand Search; Inserting And Deleting Instructions - Omron Sysmac CPM1 Operation Manual

Programming Console Operations

4-3-7 Bit Operand Search

1, 2, 3...

4-3-8 Inserting and Deleting Instructions

2. Input the address from which the search will begin and press the Down
Arrow Key. It is not necessary to input leading zeroes.
B A A
1 0 0
3. Input the instruction to be found and press the SRCH Key. In this case, the
search is for LD instructions.
In this case, the next LD instruction is at address 200, as shown below.
LD
SRCH
4. Press the Down Arrow Key to display the instruction's operands or press the
SRCH Key to search for the next occurrence of the instruction.
5. The search will continue until an END instruction or the end of Program
Memory is reached. In this case, an END instruction was reached at
address 397.
SRCH
This operation is used to find occurrences of the specified operand bit in the pro-
gram and is possible in any mode.
RUN MONITOR
OK OK
The ON/OFF status of any displayed bit will be shown if the PC is in RUN or
MONITOR mode.
1. Press the CLR Key to bring up the initial display.
2. Input the operand address. It is not necessary to input leading zeroes.
CONT
SHIFT
#
3. Press the SRCH Key to begin the search.
SRCH
4. Press the SRCH Key to search for the next occurrence of the operand bit.
5. The search will continue until an END instruction or the end of Program
Memory is reached. In this case, an END instruction was reached.
SRCH
This operation is used to insert or delete instructions from the program. It is pos-
sible in PROGRAM mode only.
RUN MONITOR
No No
00100
↓
TIM
00200SRCH
LD
00397SRCH
END(001)(00.4KW)
PROGRAM
OK
00000CONT SRCH
F
5
CONT
00200CONT SRCH
LD
00397SRCH
END(001)(00.4KW)
PROGRAM
OK
Section 4-3
001
00000
00005
00005
63