Entering Or Editing Programs - Omron CQM1 Operation Manual

Programming Console Operations
Corrected Program
00100 00101
00201 00102

3-6-11 Entering or Editing Programs

00002
2. Input the address where the NO condition will be deleted and press the
Down Arrow Key. It is not necessary to input leading zeroes.
C A F
2 0 5
3. Press the DEL Key.
4. Press the Up Arrow Key to delete the specified instruction.
If the instruction has more operands, the operands will be deleted automati-
cally with the instruction.
After completing the insertion and deletion procedures, use the Up and Down
Arrow Keys to scroll through the program and verify that it has been changed
correctly, as shown in the following diagram.
00104
00105
10000
END(01)
This operation is used enter or edit programs. It is possible in PROGRAM mode
only.
RUN
No No
The same procedure is used to either input a program for the first time or to
change a program that already exists. In either case, the current contents of
Program Memory is overwritten.
The program shown in the following diagram will be entered to demonstrate
this operation.
TIM 000
#0123
MOV(21)
#0100
LR 10
ADB(50)
#0100
#FFF6
DM 0000
00205READ
↓
AND
00205DELETE?
DEL
AND
00205DELETE END
↑
AND
Address Instruction
00205 AND
00206 AND NOT
00207 OUT
00208 END(01)
MONITOR PROGRAM
OK
Address Instruction
00200 LD
12.3 s
00201 TIM
00202 MOV(21)
00203 ADB(50)
Section 3-6
00103
00103
00105
Operands
00105
00104
10000
-
Operands
IR 00002
000
0123
#0100
LR 10
#0100
#FFF6
DM 0000
93