Log Placement (7 Log Set) - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

logs. Do not handle these logs with your bare hands. Always wear
logs, wash your hands gently with soap and water to remove any
The positioning of logs is critical to safe and clean operation of this
58 and Figure 59 and corresponding WARNING when completing
following log placement steps.
1. Lower bottom louver, lift and hinge forward.
3. Remove glass frame assembly.
4. Place front logs (#1 and #2) between grates and main burner.
Align notches on front logs with locator tabs in base.
placed between the log shelf and burner tube.
6. Place middle log (#3) between front and rear loop of burner.
7. Place right "Y" branch (#5) along side of middle log as shown
in Figure 59. Insert the pin on right "Y" branch (#5) into right
recess on rear log (#4).
8. Place bottom "Y" branch (#6) onto the middle log (#3). The
bottom left portion of the bottom "Y" branch (#6) will rest
between and slightly behind the 2nd and 3rd grates from the
left.
9. Place top branch (#7) onto rear log (#4). Insert pin on top
branch (#7) into left recess on rear log (#4). The bottom of the
top branch (#7) will rest on the left side of front log (#2).
10. Place decorative rock in front of grates and sides of main
burner.
ATTENTION
11. After all logs are properly positioned, place small "dime" size
pieces of Rockwool lightly across the front burner tube ports.
Place the ember material (Rockwool pieces) side by side. Do
not stack more than one layer of embers across the burner
ports. See Figure 59.
13. Secure the two glass frame spring clamps at bottom of
14. Close bottom cover. Lift slightly to engage the end tabs into
29354-1-1012
LOG PLACEMENT - 42" FIREPLACES
Figure
Warning: Failure to position the parts in accordance with this
with this appliance may result in property damage or
personal injury.
parts list on pages 50 - 51 and parts view on page 52 to order logs
Figure 58
Figure 59
Page 37