Introduction - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
3. Installer should show owner how to start and operate the
with all combustion air being siphoned from the outside of the
building and all exhaust gases expelled to the outside of the
building. The information contained in this manual pertains
to all models and gas control systems unless otherwise
noted.
Warning: This unit is not for use with solid fuels.
National Standard/CSA Standard ANSI Z21.88/CSA 2.33
and by Underwriters Laboratories as a Direct Vent Gas
Fireplace Heater and shall be installed according to these
instructions.
Consult your local building code agency, prior to installation,
to ensure compliance with local codes-including permits and
inspections.
in accordance with local codes or, in absence of local codes,
with the National Electric Code ANSI/NFPA 70 or Canadian
Electric code, CSA C22.1, if an external electrical source is
utilized.
These models may be installed in a bedroom or bed-sitting
room in the U.S.A. and Canada.
Installation and replacement of gas piping, gas utilization
equipment or accessories and repair and servicing of
corporation or company which either in person or through
a representative is engaged in and is responsible for (a)
the installation or replacement of gas piping or (b) the
connection, installation, repair or servicing of equipment,
who is experienced in such work, familiar with all precautions
required and has complied with all the requirements of the
authority having jurisdiction.
State of Massachusetts: The installation must be made
of Massachusetts.
Warning
CONTROLS CAN BE DANGEROUS.
carbon monoxide poisoning.
Page 6

INTRODUCTION

The installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas Code ANSI
Z223.1/NFPA 54* Natural Gas and Propane Installation Code,
or CSA B149.1 in Canada.
Standards Institute, Inc. 11 West 42nd St., New York, N.Y. 10036.
Any alteration of the original design, installed other than
as shown in these instructions or use with a type of gas
Important
All correspondence should refer to complete Model Number,
Serial Number and type of gas.
High Altitude
When installing this unit at an elevation above 2000 feet (in
the United States) it may be necessary to decrease the input
Generally, input should be reduced 4 percent for each 1000
feet above sea level. However, if the heating value of the gas
has been reduced, this general rule may not apply. Check
Canadian High Altitude
When installing this unit at an elevation above 4500 feet (in
Canada), check with local authorities.
Consult your local gas utility for assistance in determining
Preparation
and safe when installed in accordance with this Installation
Manual. Report to your dealer any parts damaged in shipment,
damaged, incomplete, or substitute parts. Read all instructions
before starting installation and follow these instructions
safety. Failure to follow them will void your warranty and may
The warranty will be voided by, and the warranter disclaims
component.
Systems, Inc.
rock.
manufactured or approved by manufacturer.
*Available from the American National
29354-1-1012