Log Placement (6 Log Set) - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

LOG PLACEMENT - 32" & 36" FIREPLACES
After handling logs, wash your hands gently with soap and water
The positioning of the logs is critical to the safe and clean operation
to Figure 56 and Figure 57 and corresponding WARNING when
completing following log placement instructions.
1. Lower bottom louver, lift and hinge forward.
3. Remove glass frame assembly.
main burner. Align notches on front logs with locator tabs in
base.
5. Place middle log (#3) between front and rear loop of burner.
be placed between the log shelf and burner tube.
7. Place right "Y" branch along side of middle log as shown in
Figure 57.
slightly behind the middle log (#3) and the pin on the branch
goes into the recess on the rear log (#4).
the branch into the recess on the middle log (#3). Rotate the
branch clockwise so that the top pin can be inserted into the
recess on the rear log (#4).
For 32" Fireplaces: The bottom of the branch is to be placed
behind the grate tang that is second from the left.
For 36" Fireplaces: The bottom of the branch is to be placed
so that it covers the seam between front logs (#1 and #2).
9. For 32" Fireplaces ONLY: Place ember chunk (#7) so that the
top slides under the middle log (#3) and the pin on front log #2
goes into the recess on the ember chunk (#7).
10. Place decorative rock in front of grates and sides of main burner
pan.
ATTENTION
EMBER MATERIAL PLACEMENT ON BURNER
11. After all logs are positioned properly, apply Rockwool ember
material to the front burner port area. To apply, carefully separate
the ember material into small amounts no larger than "dime
size" pieces. Fluffed up pieces one layer thick on top of the
burner generally works best, and will provide the best ember
glow. Do not place ember material more than one layer thick. No
more than (1) small packet of ember material (part no. 15999)
evenly placed on the burner, is recommended on DVCD32 and
DVCD36 models. Using additional ember material will decrease
the amount of ember glow effect. Extra ember material should
be saved for future ember applications as necessary. See
Figure 57.
13. Secure the two glass frame spring clamps at bottom of
14. Close bottom cover. Lift slightly to engage the end tabs into
Page 36
WARNING: Failure to position the parts in accordance
approved with this appliance may result in property damage
or personal injury.
Attention: Do not use Figure 56 or Figure 57 to order logs. Refer to
parts list on pages 50 - 51 and parts view on page 52 to order logs
Figure 56
Figure 57
29354-1-1012