Standing Pilot Lighting Instructions - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

STANDING PILOT LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. Before lighting smell all around the appliance area for
What To Do If You Smell Gas
2. Set REMOTE/OFF/ON switch to OFF.
3. Turn off all electric power to the appliance (if
applicable).
4. Lower bottom louver assembly.
5. Push in gas control knob slightly and turn clockwise
to "OFF."
GAS CONTROL KNOB SHOWN
IN "OFF" POSITION
Note: Knob cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly. Do not force.
6. Wait ten (10) minutes to clear out any gas. Then smell
you do not smell gas, go to the next
step.
7. Find pilot - Follow
metal tube from gas control. The
pilot is behind the burner on the
right side.
8. Turn gas control knob
1. Set REMOTE/OFF/ON switch to OFF.
2. Turn off all electric power to the appliance if service is
to be performed (if applicable).
3. Lower bottom louver assembly.
29354-1-1012
erty damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO FIREPLACE
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in
service technician. Force or attempted repair may
D. Do not use this appliance if any part has been under
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water.
counterclockwise
"PILOT."
9. Push in control knob all the way and hold in.
Repeatedly push the piezo ignitor button until the
pilot is lit. Continue to hold the control knob in the
for about one (1) minute after the pilot is lit. Release
knob, and it will pop back up. Pilot should remain
lit. If it goes out, repeat steps 5 through 9.
released, STOP and IMMEDIATELY
supplier.
turn the gas control knob to "OFF" and call
your service technician or gas supplier.
10. Turn gas control knob counterclockwise
"ON."
11. Close bottom louver assembly.
12. Turn on all electric power to the appliance (if
applicable).
13. Set REMOTE/OFF/ON switch to desired setting.
4. Push in gas control knob slightly and turn clock-
wise to "OFF." Do not force.
5. Close bottom louver assembly.
-
to
to
Page 41