Log Placement (4 Log Set) - Empire Comfort Systems DVP FP3 4 Series Installation Instructions And Owner's Manual

Before you begin: If you are installing logs into the DVP42 or DVP48
model then this fireplace is supplied with a set of four ceramic fiber
logs. Do not handle these logs with your bare hands. always wear
gloves to prevent skin irritation from ceramic fibers. After handling
logs, wash your hands gently with soap and water to remove any
traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace. Please refer to Figure
69, Figure 70, and Figure 71 and corresponding WARNING, when
completing the following log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of firebox
NOTE: For step by step log placement instructions with images,
see pages 41-45.
ATTENTION: Do not place decorative rock on logs or on burner.
The decorative rock should only be placed on the fireplace floor.
Figure 69
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
Page 40

LOG PLACEMENT (4 LOG SET)

WARNING
Ember Placement
1. Place decorative rock in front of grates and sides of main burner.
2. after all logs are properly positioned, place small "dime" size
pieces of Rockwool lightly across the front round "blueflame"
ports. Place the ember material (Rockwool pieces) side by side.
Do not stack more than one layer of embers across the burner
ports. See Figure 69.
3. Replace glass door onto firebox.
4. Secure the two glass frame spring clamps at bottom of firebox.
5. align the tabs on top louver brackets with slots in front posts
to secure top louver.
6. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
LOG SET PARTS LIST
PART NO.
INDEX
NO.
DVP42
! R10349
2 R10350
3 R10351
4 R10352
If flame lifts off burner and goes out, verify insulation and
retainer were removed. See page 24.
Figure 70
DESCIPTION
DVP48
R10357 REaR LOG
R10358 FRONT LEFT LOG
R10359 FRONT RIGHT LOG
R10360 TOP BRaNCH
WARNING
Figure 71
39359-0-1018