Maintenance And Service - Empire Comfort Systems DVCD32FP30P-1 Installation Instructions And Owner's Manual

PLEASE NOTE
some expansion and/or contraction noise during the start
up or cool down cycle. Similar noises are found with your
furnace heat exchanger or car engine.
undetected oil from the manufacturing process.
Please ensure that your room is well ventilated - open all
windows.
installed, place fan in the "OFF" position during this time.
IMPORTANT: Turn off gas before servicing appliance. It is
ups at the beginning of each heating season.
Keep the control compartment, logs, and burner areas surrounding
the logs clean by vacuuming or brushing at least twice a year.
Cleaning Procedure
1. Turn off pilot light at gas valve.
2. Remove glass front. (See Glass Removal)
3. Vacuum burner compartment.
4. Reinstall glass front.
5. Ignite pilot. (See Lighting Instructions)
6. Operate the pilot burner. If it appears abnormal call a service
person.
The appliance and venting system should be inspected before
Inspect the external vent cap on a regular basis to make sure
Glass Cleaning
It will be necessary to clean the glass periodically. During start-up
condensation, which is normal, forms on the inside of the glass and
causes lint, dust and other airborne particles to cling to the glass
glass. It is therefore recommended that the glass be cleaned two
or three times with a non-abrasive household cleaner and warm
glass should be cleaned two or three times during each heating
season depending on the circumstances present.
General Glass Information
WARNING: Do not operate appliance with the glass front
be used for replacement. The glass replacement should be done
WARNING:
1. The use of substitute glass will void all product warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be operated
without the glass front or with a broken glass front. Replacement
of the glass (with gasket) as supplied by the manufacturer
4. Do not abuse the glass by striking or hitting the glass.
Page 48

MAINTENANCE AND SERVICE

attempt to clean glass when glass is hot.
Glass Removal and Replacement (Figure 66)
1. Lower bottom control cover.
3. Remove glass frame.
6. Align clips on top louver with slots on front posts.
7. Close bottom control cover.
Figure 66
29354-1-1012