Fujitsu PRIMERGY BX922 S2 Operating Manual page 15

Introduction
If you want to install mezzanine cards in server blades, the system unit
must be fitted with the corresponding Fibre Channel, Infiniband and/or
Ethernet connection blades. You can find detailed information about the
equipping rules for connection blades in the operating manual for the
BX900 system unit.
Mezzanine cards may only be installed and removed by authorized,
qualified personnel. The procedure is described in the service
supplement.
SSD drives
Two SSD drives (Solid State Disk drives) can be installed in the server blade.
The connection to the onboard controller is established through ports on the
system board.
A UFM (USB flash module) can also be configured.
SATA-RAID support
RAID levels 0 and 1 are supported for operation of the SSD drives.
For more information on configuring the controller, see section
controller, configuring" on page
Graphics controller
The server blade has an onboard graphics controller (integrated in the iRMC S2
controller). A monitor can be connected via the Y cable on the front of the server
blade.
External ports
The server blade has a port for a special Y cable on the front, with 4 USB ports,
one serial port and one VGA port.
High level of availability and data security
When memory data is accessed, 1-bit errors are identified in the main memory
and automatically corrected with the error correcting code (ECC) method.
ASR&R (Automatic Server Reconfiguration and Restart) restarts the system in
the event of an error and automatically "hides" the defective system
components.
BX922 S2
50.
Operating Manual
Performance features
"onboard SATA
15