H4 Heavy Gauge Harness Wire Connection Guide; Heavy Gauge Harness Wiring Dia; Gram; Heavy Gauge Harness Wiring Guide - Clifford AvantGuard 5.1 Installation Manual

H4 heavy gauge harness wire connection guide

heavy gauge harness wiring diagram
___
H4/1
ORANGE
___
H4/2
RED
___
H4/3 ORANGE/GRAY
___
H4/4
GREEN/BLUE
___
H4/5 EMPTY
___
GRAY/ORANGE
H4/6
___
H4/7 WHITE/BLUE
___
RED
H4/8
___
GRAY
H4/9

heavy gauge harness wiring guide

All except the red heavy gauge wires leading from the relay satellite are used to ener-
gize high current circuits in the vehicle. It is crucial that these connections are made
correctly so that they are capable of handling the current demands. For this reason,
scotch locks, T-taps and other such connectors should not be used.
h4/1 orange (+) accessory output (retained)
Connect this wire to the accessory wire in the vehicle that powers the accessories in
the vehicle. This wire will retain power for 10 minutes after the ignition key is turned
off, or when a door is opened.
h4/2 red (+)12V input
N N O O T T E E : : If the factory supplies two separate (+) 12V feeds to the ignition switch, con-
nect one RED wire of the intellistart to each feed at the switch.
Remove the 30 amp fuse prior to connecting to the 12V wire and do not replace until
the intellistart installation is complete. This wire is the source of current for all the cir-
cuits the IntelliStart will energize. It must be connected to a high current source. It can
be connected to the battery or the 12V power feed to the ignition key switch (the bat-
tery is preferred).
h4/3 orange/gray (+) output to second ignition circuit
18
Accessory Output (retained)
Battery Positive (30-amp fuse) 12V (+) Input
Heater 2 Output (retained)
Battery Positive (30-amp fuse) 12V (+) Input
Heater/Air Conditioner 1 Output (retained)
Ignition 2 Output
Ignition 1 Output
Not Used
Starter Output
www.directed.com