Type D: After-Market Actuators - Clifford AvantGuard 5.1 Installation Manual

type D: after-market actuators

Vehicles without factory power door locks or with single-point central locking only
require the installation of one actuator per door. This requires mounting the door lock
actuator inside the door. Other vehicles may only require one actuator installed in the
driver's door if all door locks are operated when the driver's lock is used.
The fuse used on 12 volt inputs should be 7.5A per motor installed in the vehicle.
H2/1
#30
H2/2
#87
#87A
ON-BOARD
LOCK
RELAY
H2/3
H2/4
#30
H2/5
#87
#87A
ON-BOARD
LOCK
RELAY
H2/6
DIA-631
© 2006 directed electronics—all rights reserved
WHITE/BLACK
LOCK #87A NORMALLY CLOSED
GREEN/BLACK
LOCK #30 COMMON (OUTPUT)
VIOLET/BLACK
LOCK #87 NORMALLY OPEN (INPUT)
BROWN/BLACK
UNLOCK #87A NORMALLY CLOSED
BLUE/BLACK
UNLOCK #30 COMMON (OUTPUT)
VIOLET
UNLOCK #87 NORMALLY OPEN (INPUT)
25