Clifford AvantGuard 5.1 Installation Manual page 52

Enter the feature and press the arm/disarm button.
The lights will flash twice to confirm the engine RPM has been learned.
N N O O T T E E : : If only one flash is seen, the engine RPM was not successfully learned. Test the
tach wire connection and retry.
Turn the ignition off and activate remote start to test.
Note #5: PIN Programming.
A PIN code can have one to four digits; each digit can be from 0-9.
N N O O T T E E : : A PIN code cannot begin with a zero.
Programming Procedure
1. Enter the feature location in the user-selectable programming grid.
2. Immediately press and release
3. Select each digit by pressing
the number into the system. To enter a zero, press
To program a PIN code of 1032:
1. Press and release
3. Press and release
a zero.
5. Press and release
three chirps.
6. Press and release
two chirps.
4. Wait for two siren chirps after a five second pause or five seconds after the
last digit has been entered if using less than four digit code number.
5. Turn off the ignition; the siren will chirp three times.
6. The programming mode is now exited.
48
of the PlainView 2 Valet switch.
1-9 times, and then press
once and once. You will hear one chirp.
once. You will not hear a chirp after programming
three times, and then press
two times, and then press
to enter
only.
once. You will hear
once. You will hear
www.directed.com