Table of Contents
Advertisement
smart power up II
The Smart Power Up II feature ensures that when the security system is powered back
up after being disconnected, the system will resume the same state it was in before
power was lost. For example, if power is disconnected during a full trigger sequence,
the system will still be in the full trigger sequence when power is reconnected to the
unit. If power is disconnected while the unit is disarmed, it will still be disarmed when
power is restored.
remote control sensor disable
1.
Arm the system.
2.
Use the transmitter to bypass the sensor (G5 button twice followed by trunk button).
3.
The lights will flash four times. All warn away zones are now bypassed.
4.
Transmit the sensor bypass channel again.
5.
The lights will flash four times again. The sensor warn away and full trigger
zones are now bypassed.
6.
The sensor zones will reset when disarmed.
auto-immobilization feature
Immobilizer circuits automatically activate after 30 seconds.
N N O O T T E E : : H1/17 orange ground when armed will not activate during Auto-
Immobilization.
auto-immobilization sequence
1.
Turn ignition off or disarm alarm.
2.
After 30 seconds the systems Immobilization circuits activate and engage the
starter and ignition interrupt.
3.
LED blinks at ½ normal speed.
Disarm the system when immobilized
Use one of the following methods to turn off auto-immobilization.
Turn ignition on and press the arm/disarm button of the transmitter.
Arm the alarm and then disarm the alarm.
Turn the ignition on and enter the system valet/PIN code.
50
www.directed.com
- Quick Links:
- Wiring Reference Section
Hide quick links:
Advertisement
Table of Contents
