Page 1
World-Class Auto Security concept Owner's Manual...
Page 2
Con cept 50x is cov ered by one or more of the fol low ing Clif ford Elec tron ics U.S.A. patents: 4,158,874; 4,233,642; 4,327,444; 4,383,242; 4,430,685; 4,845,464; 4,887,064; 4,890,108; 4,922,224;...
Ta ble of Con tents Stan dard Fea tures of the Con cept 50x ..... . . 2 Your 4- button/12- channel re mote con trols ..... 6 How to use your key chain re mote con trol.
Insurance Industry’s Criteria for Vehicle Security as evaluated by Thatcham, the Motor Insurance Repair Research Centre. — For as long as you own the vehicle, Clifford will Lifetime Warranty repair or replace the control unit and remote controls free of charge (see warranty card for full details).
Page 5
UltraSecure Coded Valet Mode the system in valet mode or program in an additional remote. This ensures that no thief can turn off your Concept 50x as they can with other alarms. Re mote Con trolled Valet Mode En try and Exit your remote control, you can enter or exit valet mode.
Page 6
Your Concept 50x will even identify the specific trigger or sensor that detected the intrusion attempt.
Page 7
Patented Smart AutoTesting sensors every time you remotely arm and warns you if you accidentally arm your Concept 50x system with the bonnet or boot open. If there is a genuine trigger or sensor malfunction, the system will specifically identify the problem, thereby eliminating time-consuming and costly trouble-shooting.
(this is more effective than holding the button). The 4-button/12-channel remote control is the key to your system. It has Clifford’s Anti-CodeGrabbing (ACG) technology for the ultimate protection against “code-grabbing” devices (see page 8). You will use your remote...
30 seconds or until you start the engine, whichever occurs first. Press button 3 (channel 3). Your Concept 50x system will arm or TO SI LENTLY ARM OR DIS ARM disarm with all the indications noted above except for the chirp THE SYS TEM.
Your remote control will never transmit the same code twice, and the control unit will never accept the same code twice. Thus the code recorded and played back by the thief’s code-grabber will never be accepted by your Concept 50x. Smart prior intrusion attempt alert If you hear three chirps when you remotely disarm instead of the usual one chirp, it means that a trigger or sensor was activated in your absence.
For your convenience, if you re-open any door(s) within the 30-second countdown, AutoArming will restart from the beginning once all doors are closed. Concept 50x has these additional AutoArming features: AutoArming en able/dis able: the AutoArming feature.
Ul traSe cure Coded Valet Mode Your se cret valet code NOTE: If you tem po rar ily lose the use of your re mote con trols, you can dis arm the sys tem by ena bling valet mode. All car alarms have a valet mode that turns off the security features. This mode is also used to turn off the alarm if it is not responding to the remote.
To en able valet mode 1. Turn the ignition switch to its “ON” position or start the engine. 2. Enter your valet code on the PlainView switch, then return the switch to its centre position. 3. You now have 5 seconds to press the latched position to enter valet mode. The system’s LED will glow continually for ongoing visual confirmation of valet mode.
Concept 50x to issue its warning tone. But if a thief actually leans into the passenger compartment, the sensor’s interior zone will be triggered and the system will instantly blast the full alarm sound.
Indicator will repeatedly flash to indicate that AutoImmobilisation has been activated. Even if a thief were to cut all the wires or even find the Concept 50x control unit and disconnect it, he would still be unable to start the engine.
This prevents battery drain. Long- term chirp si lenc ing: Concept 50x’s arm/disarm chirps until you wish to restore them. The indicator light flashes will continue to provide visual confirmation of remote controlled arming and disarming.
PlainView switch. Once you’ve changed a few settings, you’ll find that programming Concept 50x is so easy that you can even do it whilst driving! The system comes with all of its features preprogrammed as noted by the bold type in the Table of user-selectable features on pages 19-20.
Page 19
EX AM PLE 1: Turn on AutoArm & Lock When the system AutoArms (see page 9), it does not normally lock the doors to ensure that you cannot accidentally lock the keys inside the vehicle. To enable this feature, you’ll note that “AutoArm & Lock” is in column 3, row 2 of the table on pages 19-20. The “...
(but not over-tightening) the retaining screw. Adding new remote controls For other drivers in your family, or if you wish to control Concept 50x systems on your other cars with the same remote control, you can buy additional remote controls from any Clifford Dealer (call our UK office on ring on 0800-929949 or 0181-646-8440 for the nearest dealers) and program them into the system yourself.