Clifford AvantGuard 5.1 Installation Manual page 23

Connect this wire to the second ignition wire in the vehicle.
h4/4 green/blue (+) ignition output
Connect this wire to the ignition wire in the vehicle.
h4/6 gray/orange heater 2 output (retained)
Connect this wire to the second accessory wire in the vehicle that powers the climate
control system. This wire will retain power for 10 minutes after the ignition key is
turned off, or until a door is opened.
h4/7 white/blue (+) starter output
Connect this wire to the starter wire in the vehicle.
h4/8 red (+)12V input
N N O O T T E E : : If the factory supplies two separate (+) 12V feeds to the ignition switch, con-
nect one RED wire of the satellite to each feed at the switch.
Remove the 30 amp fuse prior to connecting this wire and do not replace them until
the satellite has been plugged into the control module. This wire is the source of cur-
rent for all the circuits the relay satellite will energize. It must be connected to a high
current source. Since the factory supplies (+) 12V to the key switch that is used to
operate the motor, it is recommended that this wire be connected there.
h4/9 gray heater/air conditioner 1 output (retained)
Connect this wire to the accessory wire in the vehicle that powers the climate control
system. This wire will retain power for 5 minutes after the ignition key is turned off, or
until a door is opened.
© 2006 directed electronics—all rights reserved
19