Primary Harness (H1) Wire Connection Guide; Primary Harness Wiring Diagram; Primary Harness Wiring Instructions - Clifford Matrix +1 Installation Manual

Primary Harness (H1) Wire Connection
Guide

Primary Harness Wiring Diagram

ORANGE
H1/1
___
WHITE
H1/2
___
WHITE/BLUE
H1/3
___
BLACK/WHITE
H1/4
___
H1/5 GREEN
___
H1/6 BLUE
___
H1/7 VIOLET
___
H1/8
BLACK
___
H1/9
YELLOW
___
H1/10
BROWN
___
H1/11
RED
___
H1/12
RED/WHITE
___

Primary Harness Wiring Instructions

This guide describes in detail the connection of each wire. Also included are
possible applications of each wire. This system was designed with the ultimate
in flexibility and security in mind. Many of the wires have more than one
possible function. Please read carefully to ensure a thorough understanding
of this unit.
H1/1 ORANGE (-) ground-when-armed output
This wire supplies a (-) ground as long as the system is armed. This output
ceases as soon as the system is disarmed. The orange wire is pre-wired to control
the 8618 starter kill relay. It can supply up to 500 mA of current.
NOTE: If using the H1/1 Orange wire to activate an add-on accessory such
as window automation, or voice module a 1Amp diode must be installed to
ensure proper operation. Insert the diode as shown in the following diagram.
4
(-) 500 mA Armed Output
(+)/(-) Selectable Light Flash Output
(-) 200 mA Channel 3 Programmable Output
(-) 200 mA Domelight Supervision Output
(-) Door Trigger Input, Zone 3
(-) Instant Trigger Input, Zone 1
(+) Door Trigger Input, Zone 3
(-) Chassis Ground Input
(+) Switched Ignition Input, Zone 5
(+) Constant Power Input
(-) 200 mA Channel 2 Output
© 20 0 8 D i re cte d E l ec tro n i cs- Al l ri g ht s res e r v e d.
(+) Siren Output