Guide; Secondary Harness Wiring Diagram; Secondary Harness Wiring Guide10; Pigtail Harness Wire Connection - Clifford Concept 650MkII Installation Manual

cle has a positive switched interior light circuit, attach this wire to a 12 volt constant source.
secondary harness wire connection guide

secondary harness wiring diagram

___
BROWN/BLACK
H2/1
___
WHITE/BLACK
H2/2
___
VIOLET/BLACK
H2/3
___
BROWN/WHITE
H2/4
___
BLUE/BLACK
H2/5
___
VIOLET
H2/6
___
GREEN/BLACK
H2/7
___
BROWN/RED
H2/8
secondary harness wiring guide
N N O O T T E E : : For the wires not discussed below, please refer to the Door Lock Harness
Wire Connection Guide section.
h2/4 brown/white brake light output
When activated by the Blackjax* feature this wire powers the brake light circuit from
the 12-volt source on H2/8.
h2/8 brown/red brake light (+) 12V input
This is the polarity source for the brake light output and must be 12 volt constant.
pigtail harness wire connection guide (h3
and h4)

h3 connector (male)

Locate the ignition and starter wires using a multimeter. Cut the appropriate wire and
attach the key side and car side wires to the corresponding wires on the four-pin
immobiliser harness.
10
Unlock 87A (Normally Closed)
Lock 87A (Normally Closed)
Lock 87 (Normally Open)
Brake Light Output (30)
Unlock 30 (Common)
Unlock 87 (Normally Open)
Lock 30 (Common)
Brake Light (+) 12V Input (87)
www.directed.com