xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
To view this window, click Monitoring > sFlow > sFlow Counter Poller Settings as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
Analyzer Server ID
Interval
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries listed.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Ping
Broadcast Ping Relay Settings
This window is used to enable or disable broadcast ping reply state, device will reply broadcast ping request.
To view this window, click Monitoring > Ping > Broadcast Ping Relay Settings as shown below:
The fields that can be configured are described below:
Parameter
Broadcast Ping Relay State
Click the Apply button to accept the changes made.
Figure 11-23 sFlow Counter Poller Settings
Description
Select the unit you wish to configure.
Use the drop-down menus to specify the list of ports to be configured.
The analyzer server ID specifies the ID of a server analyzer where the packet will be
forwarded.
The maximum number of seconds between successive samples of the counters.
Figure 11-24 Broadcast Ping Relay Settings window
Description
Click the radio buttons to enable or disable broadcast ping relay state.
373