D-Link xStack DGS-3420 Series Reference Manual page 303

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Successful authentication using any of these methods will give the user an "Admin" privilege.
NOTE: To set the Local Enable Password, see the next section, entitled Local Enable Password.
To view this window, click Security > Access Authentication Control > Enable method Lists Settings as shown
below:
To delete an Enable Method List defined by the user, click the Delete button corresponding to the entry desired to
be deleted. To modify an Enable Method List, click its corresponding Edit button.
The fields that can be configured are described below:
Parameter
Method List Name
Priority 1, 2, 3, 4
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Figure 8-71 Enable method Lists Settings window
Description
Enter a method list name defined by the user of up to 15 characters.
The user may add one, or a combination of up to four of the following authentication
methods to this method list:
local_enable - Adding this parameter will require the user to be authenticated using
the local enable password database on the Switch. The local enable password must
be set by the user in the next section entitled Local Enable Password.
none - Adding this parameter will require no authentication needed to access the
Switch.
radius - Adding this parameter will require the user to be authenticated using the
RADIUS protocol from a remote RADIUS server.
tacacs - Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
xtacacs - Adding this parameter will require the user to be authenticated using the
XTACACS protocol from a remote XTACACS server.
tacacs+ - Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
293