D-Link xStack DGS-3420 Series Reference Manual page 339

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter Description
SMTP State Use the radio button to enable or disable the SMTP service on this device.
SMTP Server Enter the IP address of the SMTP server on a remote device. This will be the device that
Address sends out the mail for you.
SMTP Server
Enter the virtual port number that the Switch will connect with on the SMTP server. The
Port common port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.
Self Mail Enter the e-mail address from which mail messages will be sent. This address will be the
Address "from" address on the e-mail message sent to a recipient. Only one self-mail address can be
configured for this Switch. This string can be no more that 64 alphanumeric characters.
Add a Mail Enter an e-mail address and click the Add button. Up to eight e-mail addresses can be added
Receiver per Switch. To delete these addresses from the Switch, click the corresponding Delete button
in the SMTP Mail Receiver Address table at the bottom of the window.
Send a Test
Here the user can send a test mail to all the addresses listed.
Mail to All
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
Figure 9-36 SMTP Settings window
329