D-Link xStack DGS-3420 Series Reference Manual page 426

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Stacking swUnitInsert
swUnitRemove
swUnitFailure
swUnitTPChange
swUnitRoleChange
Port Security swL2PortSecurityViolationTrap
Safeguard swSafeGuardChgToNormal
swSafeGuardChgToExhausted
LBD swPortLoopOccurred
swPortLoopRestart
swVlanLoopOccurred
swVlanLoopRestart
BPDU Attack swBpduProtectionUnderAttackingTrap BPDU attack happened, enter drop / block /
Protection
swBpduProtectionRecoveryTrap
(OID:)
IMPB swIpMacBindingViolationTrap
swIpMacBindingIPv6ViolationTrap
DHCP Server swFilterDetectedTrap
(4) agentGratuitousARPInterfaceName
Unit Hot Insert notification.
Binding objects:
(1) swUnitMgmtId.
(2) swUnitMgmtMacAddr.
Unit Hot Remove notification.
Binding objects:
(1) swUnitMgmtId.
(2) swUnitMgmtMacAddr.
Unit Failure notification.
Binding objects:
(1) swUnitMgmtId.
The stacking topology change notification.
Binding objects:
(1) swStackTopologyType
(2) swUnitMgmtId
(3) swUnitMgmtMacAddr
The stacking unit role change notification.
Binding objects:
(1) swStackRoleType
(2) swUnitMgmtId
When the port security trap is enabled, new MAC
addresses that violate the pre-defined port security
configuration will trigger trap messages to be sent
out.
Binding objects:
(1)swPortSecPortIndex
(2)swL2PortSecurityViolationMac
This trap indicates system change operation mode
from axhausted to normal.
Binding objects:
(1) swSafeGuardCurrentStatus
This trap indicates System change operation mode
from normal to exhausted.
Binding objects:
(1) swSafeGuardCurrentStatus
The trap is sent when loop back is detected under
port-based mode.
Binding objects:
(1) swLoopDetectPortIndex
The trap is sent when port recovered from LBD
blocked state under port-based mode.
Binding objects:
(1) swLoopDetectPortIndex
The trap is sent when loop back is detected under
VLAN-based mode.
Binding objects:
(1) swLoopDetectPortIndex
(2) swVlanLoopDetectVID
The trap is sent when port recovered from LBD
blocked state under VLAN-based mode.
Binding objects:
(1) swLoopDetectPortIndex
(2) swVlanLoopDetectVID
shutdown mode.
Binding objects:
(1)swBpduProtectionPortIndex
(2)swBpduProtectionPortMode
BPDU attack automatically recover
Binding objects:
(1)swBpduProtectionPortIndex
(2)swBpduProtectionRecoveryMethod
When the IP-MAC Binding trap is enabled, if there's
a new MAC that violates the pre-defined port
security configuration, a trap will be sent out.
Binding objects:
(1) swIpMacBindingPortIndex
(2) swIpMacBindingViolationIP
(3) swIpMacBindingViolationMac
When the IP-MAC Binding trap is enabled, if there's
a new MAC that violates the pre-defined IPv6 IP-
MAC Binding configuration, a trap will be sent out.
Binding objects:
(1) swIpMacBindingPortIndex
(2) swIpMacBindingViolationIPv6Addr
(3) swIpMacBindingViolationMac
Send trap when an illegal DHCP server is detected. 1.3.6.1.4.1.171.12.37.10
416
1.3.6.1.4.1.171.12.11.2.
2.1.0.1
1.3.6.1.4.1.171.12.11.2.
2.1.0.2
1.3.6.1.4.1.171.12.11.2.
2.1.0.3
1.3.6.1.4.1.171.12.11.2.
2.1.0.4
1.3.6.1.4.1.171.12.11.2.
2.1.0.5
1.3.6.1.4.1.171.11.119.
X.2.100.1.2.0.2,(X:mod
ule ID)
1.3.6.1.4.1.171.12.19.4.
1.0.2
1.3.6.1.4.1.171.12.19.4.
1.0.1
1.3.6.1.4.1.171.12.41.10
.0.1
1.3.6.1.4.1.171.12.41.10
.0.2
1.3.6.1.4.1.171.12.41.10
.0.3
1.3.6.1.4.1.171.12.41.10
.0.4
1.3.6.1.4.1.171.12.76.4.
0.1
1.3.6.1.4.1.171.12.76.4.
0.2
1.3.6.1.4.1.171.12.23.5.
0.1
1.3.6.1.4.1.171.12.23.5.
0.4