D-Link xStack DGS-3420 Series Reference Manual page 139

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
VLAN Name
VID
Remap Priority
Replace Priority
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
Click the Delete button to remove the specific entry.
Click the Profile List link to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
After clicking the Edit button, the following page will appear:
The fields that can be configured are described below:
Parameter
State
Replace Source IP
Remap Priority
packet VLAN. If this function is disabled, the Switch will do VID checking first. If the
group does not match the current profile binding to the multicast VLAN, the Switch will
drop this packet.
Enter the VLAN name used.
Enter the VID value used.
The user can select this option to enable the Remap Priority feature.
Specify the remap priority (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN. If None is specified, the packet's original priority
will be used. The default setting is None.
Tick the check box to specify that the packet's priority will be changed by the switch,
based on the remap priority. This flag will only take effect when the remap priority is
set.
Figure 4-85 MLD Snooping Multicast VLAN Settings – Edit window
Description
Use the drop-down menu to enable or disable the state.
With the MLD snooping function, the MLD report packet sent by the host will be
forwarded to the source port. Before forwarding of the packet, the source IP
address in the join packet needs to be replaced by this IP address. If none is
specified, the source IP address will use zero IP address.
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet's original priority is used. The default
setting is None.
129