Powerware BPIV Installation & Operation Manual page 38

NOTE: In the following step the pallet will tilt and act as a ramp once the cabinet is
rolled beyond the the center of the pallet. Make sure to restrain the cabinet
as it continues to roll down the pallet/ramp. The front shipping bracket will
act as a brake to assist restraining the cabinet.
WARNING:
Do not stand directly behind the pallet while unloading the cabinet If
unloading instructions are not closely followed, the cabinet may cause
serious injury.
7.
Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts,
continue rolling the cabinet down the pallet until the cabinet is clear of the
pallet.
8.
Remove four bolts, (2) in Figure 2---5, securing front shipping bracket to the
cabinet.
9.
If installing cabinet permanently, retain shipping brackets and hardware;
otherwise, discard or recycle the pallet and brackets in a responsible manner.
10.
Roll cabinet to final installation location.
11.
If permanently mounting the system, proceed to step 15; otherwise, proceed to
step 12.
12.
Secure the UPS cabinet in position by lowering the leveling feet, until cabinet is
not resting on the casters and the cabinet is level.
13.
If installing Battery and Options cabinets, proceed to step 14; otherwise,
proceed to paragraph 2.2.4.
14.
Install Battery and Options cabinets, by repeating steps 1 through 10 for
remaining cabinets and then proceed to paragraph 2.3 for Battery cabinet
installation and paragraph 2.4 for Options cabinet installation.
15.
Using retained hardware, reinstall shipping brackets previously removed to
front and rear of UPS cabinet with the angle facing outward (see Figures 2---5
and 2---6).
16.
If installing Battery and Options cabinets, proceed to step 17; otherwise,
secure cabinet to floor with contractor supplied hardware and proceed to
paragraph 2.2.4.
17.
Install Battery cabinets and Options cabinet, by repeating steps 1 through 10
for remaining cabinets and then proceed to paragraph 2.3 for Battery cabinet
installation and paragraph 2.4 for Options cabinet installation.
2--12
Powerware BPIV (10 kVA- -30 kVA) Installation and Operation
164201406 Rev. C 013004