Compaq ProLiant ML350 Setup And Installation Manual page 69

To replace the lithium battery:
CAUTION: Before removing the access panel, make sure that the server is
powered down, all cables are disconnected from the back of the server, and the
power cord is disconnected from the grounded (earthed) AC outlet.
CAUTION: Static electricity can damage electronic components of the server.
Before beginning these procedures, be sure you are discharged of static
electricity by briefly touching a grounded (earthed) metal object.
1. Follow the steps in "Removing the Access Panel" at the beginning of
this chapter.
2. Locate the battery on the system board.
NOTE: If you have expansion boards installed, you may need to remove them to access
the battery.
Figure 3-38. Locating the battery on the system board
For use with 1-GHz or greater Intel Pentium III processor-based server models only
Hardware Options Installation 3-37