Compaq ProLiant ML350 Setup And Installation Manual page 50

3-18 Compaq ProLiant ML350 Setup and Installation Guide
Installing a Tape Drive
To install a tape drive:
CAUTION: Before removing the access panel, make sure that the server is
powered down, all cables are disconnected from the server, and the power cord
is disconnected from the grounded (earthed) AC outlet.
1. Follow the steps in "Removing the Access Panel" at the beginning of
this chapter.
2. Install guide screws on the sides of the drive.
3. To configure the device, set the SCSI device ID. You must manually set
the SCSI device ID on each device to a unique value in the range of
0 to 6 for each SCSI bus. Refer to the documentation provided with the
drive for instructions on setting the SCSI device ID.
4. Slide the drive into the drive bay until it clicks into place.
Figure 3-20. Installing a tape drive
NOTE: The interior of the server may look different depending on the model purchased.
NOTE: Compaq recommends installing the tape drive on a separate SCSI cable to avoid a
decrease in performance of other SCSI devices.
For use with 1-GHz or greater Intel Pentium III processor-based server models only