Compaq ProLiant ML350 Setup And Installation Manual page 36

3-4 Compaq ProLiant ML350 Setup and Installation Guide
3. Open the bezel fully to the right.
4. Loosen the two thumbscrews
chassis.
5. Slide the access panel
6. Lift and remove the panel.
7. Turn the access panel over to locate the System Configuration Label.
This label provides information on installing processor board options,
configuring drives, installing drives, and setting switches.
Figure 3-3. Loosening the thumbscrews and removing the access panel
To replace the access panel, reverse the above procedure.
For use with 1-GHz or greater Intel Pentium III processor-based server models only
located on the left side of the front


back about 1.5 cm (0.5 in).

2
1