Compaq ProLiant ML350 Setup And Installation Manual page 32

2-8 Compaq ProLiant ML350 Setup and Installation Guide
8. You may configure certain system features using either the SmartStart
and Support Software CD (recommended) or RBSU that is embedded in
the server ROM.
Place the SmartStart and Support Software CD in the CD-ROM
drive and power up the server again. Follow the onscreen
instructions to complete the server initialization process. For
SmartStart and Support Software CD initialization procedures, refer
to the Server Setup and Management pack shipped with your server
or see Chapter 5, "Server Configuration and Utilities."
-Or-
Run RBSU by pressing F9 when prompted in the lower right corner
of the screen. Use RBSU to verify the type of operating system,
verify the boot controller order, and set the date and time. For
information on using RBSU to configure other server features, see
Chapter 5, "Server Configuration and Utilities."
9. Install the operating system.
10. Install Compaq Insight Manager to manage the server. For Compaq
Management CD initialization procedures, refer to the Server Setup and
Management pack shipped with your server.
IMPORTANT: You must install and use Compaq Insight Manager to benefit from the
Compaq Pre-Failure Warranties on processors, hard drives, and memory modules.
11. Install any application software needed.
12. Register your server. For server registration information, refer to the
Server Setup and Management pack shipped with your server or register
your Compaq server online at
www.compaq.com/register
Send us your name, server serial number, and operating system (OS)
information. You may also use your Compaq Server Profile Diskette to
register after configuring your server with SmartStart. Simply follow the
instructions on our website and insert the Compaq Server Profile
Diskette when prompted.
For use with 1-GHz or greater Intel Pentium III processor-based server models only