Setup; Adjusting The Armrest Width; Adjusting The Armrest Angle; Replacing Armrest Pad - Invacare Leo User Manual

5 Setup

5.1 Adjusting the Armrest Width

WARNING!
– Do not pull the armrest tube out of the seat frame
beyond the STOP label on the armrest. Otherwise,
the armrest tube may fall out of the seat frame and
cause injury or damage.
B
Loosen the knob A securing the armrest tube B to the seat
1.
frame C.
2. Push the armrest in or out to the desired position.
3. Tighten the knob to secure the armrest tube to the seat frame
4. If necessary, repeat STEPS 1–3 to adjust the remaining armrest.

5.2 Adjusting the armrest angle

CAUTION!
Pinch point may occur when adjusting the arm
angle
– Pay attention to your fingers.
1506942-P
A
1. Lift up the armrest.
2. Loosen the jam nut A.
3. Adjust the socket screw B up or down to the desired arm angle
position.
4. Tighten the jam nut.
5. To determine the same angle for the opposite armrest, count
the exposed threads after the jam nut has been tightened.
6. Repeat STEPS 1-4 for opposite armrest, if necessary.

5.3 Replacing Armrest Pad

Remove the mounting screw A and washer B that secure the
1.
armrest pad C to the armrest D.
2. Remove the old armrest pad.
3. Use the mounting screw and washer to install the new armrest
pad. Securely tighten.
4. If necessary, repeat STEPS 1-3 to replace the other armrest pad.
Setup
A
19