Electrical Ignition; Some Field Values; Fuel Feed - RIKA INTEGRA II Instruction Manual

9. ELECTRIC IGNITION
The pellet furnace is fitted with an electric ignition.
This starts to function together with the stove start
program.
Ignition duty cycle: Approx. 12 min.
PRE-HEATING
ELECTRIC IGNITION
● ● ● ●
CAUTION: APPLIES ONLY TO STOVES WITHOUT

ELECTRICAL IGNITION

● ● ● ●
If your stove is fitted with electric ignition and this
is faulty - please request a service or repair visit!
If your pellet stove is not fitted with electric ignition
proceed as follows:
1. Check that the pellet container is full and the
combustion chamber is clean and free from
impurities. Place approved firelighters in the fire
pan and lay a small handful of pellets on top.
CAUTION: Do not use flammable liquids to
preheat the stove!
2. Light the firelighters in the fire pan using a
match and close the stove doors carefully. Press the
"ON/OFF" button. This setting starts the start
procedure.

SOME FIELD VALUES

Pellet consumption depends on the size of the
pellets. The larger the pellets the slower the feed
and vice versa.
30 kg of pellets should be sufficient for 16 hours of
operation at a setting of "100%", and about 50 hours
at a setting of "0%" (there may be variations caused
by differences in pellet fuel).
If you have any questions please contact your
authorised pellet stove dealer
WITHOUT

FUEL FEED

CAUTION when filling the stove with pellets! Do not
touch the hot stove with the pellet sack. Remove any
pellets that have not been put in the storage container
immediately (Smoke formation)!
To prevent the fire from going out due to lack of fuel,
we recommend that an adequate pellet level is kept
in the storage container. Check the filling level often.
The container lid should however always be kept
closed unless the container is being filled.
Pellet
specification).
- 21 -
container capacity (see technical