RIKA INTEGRA II Instruction Manual page 19

Hide thumbs Also See for INTEGRA II:
Table of Contents

Advertisement

Start automatic operation (TM mode)
When TM is selected on the display and the
programmed heating time begins the control starts
the heating operation.
The following flashing indications appear alternately
on the display:
"TM" indicates automatic operation.
On completion of the start phase the following
appears continuously on the display
Generally the pre-programmed heating output (PS,
PE) is adopted. If however youwant to change the
current value, then this can be done by pressing the
"+" or "-" keys in 5% steps. The changed value
appears on the display. The program adopts the
new value for the control until the completion of the
current heating window. On starting the following
heating time the programmed value is re-used. A
permanent change of heating output can only be
achieved by programming PS and PE.
Note:
The pre-heating program runs automatically and can
be stopped by changing ("ENTER" key) the operating
state to "SB". In this case the out of operation mode
(alternating indication "Ex", see below) runs through
to the end. If the stove is disconnected from the mains
supply (i.e. power cut) during the start phase and then
re-connected to the mains supply, the start phases
starts from the beginning again.
PLACE STOVE OUT OF OPERATION
Switching off from "Manual operation" (ON)
If the "ON/OFF" key is pressed during operation
then the switch off program is activated. The
following alternating flashing indictors appear on the
display:
"Ex" Exit phase 1
The number below is the remaining time in seconds
for this phase.
On completion of Exit phase 1 the display shows
(flashing):
"CL" Cleaning phase
The number below is the remaining time in seconds
for this phase.
On completion of Exit phase 1 the display shows
(flashing):
"Ex" Exit phase 2
The number below is the remaining time in seconds
for this phase.
Note:
The full switching off process lasts for about 8
minutes and cannot be interrupted by the user. On
confirmation of "ON/OFF" the switch off program is
initialised.
- 19 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents